PRODUCTS

biRAPID​
Controller for Software Development​​​​​
HECS-B/A

Compact Size with various functions embedded

12 signaling gate output unit equipped with High-ended TI Microprocessor and Xillinx FPGA that allow various of pulse pattern generation, and capable of driving 2 units of three-phase inverter parallelly.​

Compact A6 size design that suitable for system integration.​
12 bits AD conversion, and embedded with CAN communication system.​

Compact Size with various functions embedded

​High performance Microprocessor integrated with FPGA embedded in a compact size.​
Capable of PWM output, AD conversion, and other communication functions embedded.​

Suitable for software development and debug​

Can be connect via either PC or USB port​
Along with our HSDT-KIT-B, a SW Development and Debug can be setup.​

Various I/O

12 Gate Signals output, 16 ch AD input, 16ch DI, 16 Ch DO and compact port with a variety of I/O.​​

Specification (Model: HEC-B/A)

Micro Processor​ TITMS320F28377S (Texas Instruments)​ 200 MHz Clock Frequency​
FPGA​ XC6SLX45 (Xillinx)​ Spartan-6​
Gate Signal output​ 12 port​ 5V TTL​
Error-Link I/F​ 4ch​ 5V TTL​
AD Input​ 16ch​ +/- 5V, 100kHz​
Digital Input​ 16ch​ 5V​
Digital Output​ 16ch​ OC Output
DC5~30V/50mA​
Dim(mm)​ W:90mm​ / D:130mm​ / H:130mm
Operational Temperature​ 0~50℃​ No Condensing
Power Supply​ DC10.8~26.4V​
Power Consumption​ Less than 18W​

Related Function with our other products​

Circuit Block I/F
(Main Circuit)​
6ch Interface directly to Circuit Block Maximum 6 Circuit blocks.​
Error Link I/F​ 4ch Interface for Error Link Function with other platform products. ​
Maximum 4 links. ​
Our HSDT I/F​ 1ch Interface to HSDT-Data Processor.​

Main Function​

PWM Generator​ 12 port​ Complement PWM Generator with Dead-time Function. Carrier wave can be selected from sine-wave, sawtooth-wave and reverse sawtooth-wave.​
Digital In/Out​ 16 Ch each​ Isolated Universal Digital Input / Output.​
AD Conversion​ 16 Ch 12bit AD Conversion Function. Embedded microprocessor and FPGA can be used independently.​
Comparator​ 8 Ch​ Comparing input voltage with upper and lower threshold and activate Gate Block function whenever it is exceeded.​
Universal LED​ Yellow x 4​
Red x 4​
Controlled by embedded program.​
Universal Dip Switch​ 4 Ch​ Read by embedded program.​
Asynchronous Serial Com Port ​ 3 Ch​ RS485, RS232C and USB-UART are usable.​
CAN Com Port​ 2 Ch​ CAN port isolated from circuit board​
EEPROM​ 512kBit Embedded program to access EEPROM through I2C connection​

Block Diagram